Search results
Results From The WOW.Com Content Network
Delta-sigma ( ΔΣ; or sigma-delta, ΣΔ) modulation is an oversampling method for encoding signals into low bit depth digital signals at a very high sample-frequency as part of the process of delta-sigma analog-to-digital converters (ADCs) and digital-to-analog converters (DACs). Delta-sigma modulation achieves high quality by utilizing a ...
Oversampling. In signal processing, oversampling is the process of sampling a signal at a sampling frequency significantly higher than the Nyquist rate. Theoretically, a bandwidth-limited signal can be perfectly reconstructed if sampled at the Nyquist rate or above it. The Nyquist rate is defined as twice the bandwidth of the signal.
A 1-bit DAC (sometimes called Bitstream converter by Philips) is used as a consumer electronics marketing term describing an oversampling digital-to-analog converter (DAC) that utilizes a digital noise shaping delta-sigma modulator operating at many multiples of the sampling frequency that outputs to an actual 1-bit DAC (which could be fully differential to minimize crosstalk).
To achieve high signal-to-noise ratio, delta modulation must use oversampling techniques, that is, the analog signal is sampled at a rate several times higher than the Nyquist rate. Derived forms of delta modulation are continuously variable slope delta modulation, delta-sigma modulation, and differential modulation.
A delta-sigma ADC (also known as a sigma-delta ADC) is based on a negative feedback loop with an analog filter and low resolution (often 1 bit) but high sampling rate ADC and DAC. The feedback loop continuously corrects accumulated quantization errors and performs noise shaping : quantization noise is reduced in the low frequencies of interest ...
This results in a broadband dynamic range of only 7.78 dB, but it is not consistent among frequency bands, and in the lowest frequencies (the audible range) the dynamic range is much greater — over 100 dB. Noise shaping is inherently built into the delta-sigma modulators. The 1-bit converter is the basis of the DSD format by Sony.
Oversampling DACs or interpolating DACs such as those employing delta-sigma modulation, use a pulse density conversion technique with oversampling. Audio delta-sigma DACs are sold with 384 kHz sampling rate and quoted 24-bit resolution, though quality is lower due to inherent noise (see § Figures of merit).
For example, for a 20 kHz analog audio sampled at 4× oversampling with second-order noise shaping, the dynamic range is increased by 30 dB. Therefore, a 16-bit signal sampled at 176 kHz would have a bit depth equal to a 21-bit signal sampled at 44.1 kHz without noise shaping. Noise shaping is commonly implemented with delta-sigma modulation.