Search results
Results From The WOW.Com Content Network
e. Delta-sigma (ΔΣ; or sigma-delta, ΣΔ) modulation is an oversampling method for encoding signals into low bit depth digital signals at a very high sample-frequency as part of the process of delta-sigma analog-to-digital converters (ADCs) and digital-to-analog converters (DACs). Delta-sigma modulation achieves high quality by utilizing a ...
A delta-sigma ADC (also known as a sigma-delta ADC) is based on a negative feedback loop with an analog filter and low resolution (often 1 bit) but high sampling rate ADC and DAC. The feedback loop continuously corrects accumulated quantization errors and performs noise shaping : quantization noise is reduced in the low frequencies of interest ...
8-channel Cirrus Logic CS4382 digital-to-analog converter as used in a sound card. In electronics, a digital-to-analog converter (DAC, D/A, D2A, or D-to-A) is a system that converts a digital signal into an analog signal. An analog-to-digital converter (ADC) performs the reverse function. There are several DAC architectures; the suitability of ...
This results in a broadband dynamic range of only 7.78 dB, but it is not consistent among frequency bands, and in the lowest frequencies (the audible range) the dynamic range is much greater — over 100 dB. Noise shaping is inherently built into the delta-sigma modulators. The 1-bit converter is the basis of the DSD format by Sony.
A 1-bit DAC (sometimes called Bitstream converter by Philips) is a consumer electronics marketing term describing an oversampling digital-to-analog converter (DAC) that uses a digital noise shaping delta-sigma modulator operating at many multiples of the sampling frequency that outputs to an actual 1-bit DAC (which could be fully differential to minimize crosstalk). [1]
A comparator to perform the function s(xi − x) by comparing the DAC's voltage with the input voltage. A register to store the output of the comparator and apply xi−1 − s(xi−1 − x)/2i. Operation of successive-approximation ADC as input voltage falls from 5 to 0 V. Iterations on the x axis. Approximation value on the y axis.
Integrating ADC. An integrating ADC is a type of analog-to-digital converter that converts an unknown input voltage into a digital representation through the use of an integrator. In its basic implementation, the dual-slope converter, the unknown input voltage is applied to the input of the integrator and allowed to ramp for a fixed time period ...
t. e. Pulse-width modulation (PWM), also known as pulse-duration modulation (PDM) or pulse-length modulation (PLM), [1] is any method of representing a signal as a rectangular wave with a varying duty cycle (and for some methods also a varying period). PWM is useful for controlling the average power or amplitude delivered by an electrical signal.